Here we go....so far about 40 miles and all is good. ACL bearings were great, all of them were within factory specs.
I guess the pics will explain it all.

Darton sleeves...available through me.

The bottom end

The head....4 angle p&p. 1mm ferrea oversized on intake and exhaust. Stock cams and gears for now, gonna see what I can make with them.


The final pic of the motor in the car


Thanks to Earl for the PWR IC...it'll be goin in next week hopefully, that is if I get it back from getting anodized black


And here is some alternative transportation that we have at the shop to sell----yeah right, were gonna hook them up and drive them around at the track!!

 

So does the IC have its own desk too? I see it has its own chair..

art

 

nice...

I also had very good results with the acl bearings.

I just finished up my setup too but...
I wish that my motor would just stop smoking...




[Modified by highbrid, 10:32 PM 11/27/2002]

 

awww man. i didn't get to help at all. glad to see it all in and hear that it is running good.

 

what manifold is that, got any more pics of it???

 

Yeah I could have used some help...you would have probably been bored though cause Im so ****. Every bolt on the exterior of the motor was wire wheeled, all the specs were gone over like 5 times, etc etc.
The only thing that sucks is that I cant keep the thing running coming down off of RPM's since I did away with the cold air idle valve and the other sensor behind the manifold cause of the vemon intake.

 

Looks good...

Hey Dan, don't know if you'll remember me, but we met at Atco awhile ago.
Where is your shop located? How much were the sleeves and all the block work? I eventually want to build my motor and need a good place to go to.

 

Awesome setup!!! very nice.

But I notice one thing that seems strange with such a ***** out setup. Why the stock radiator. I'm not knit picking the setup, I'm just curious why no upgrade.

How much will those lil units take anyway?

Ohh and can I get one of those scooters at a H-T discount?

 

It looks really nice but are you gonna keep the intercooler piping like that?

 

Nice...

 

Woo hooo Flat tops!!

 

Yeah.....somebody couldn't get me MY flat tops so i'm stuck with **** poor compression ratio....J/K Dan Looking good d00d

My POS is finally running although it's gonna need a valve lash adjustment again, she's kinda noisy. What size injectors you got going into that bad boy?

 

nice motor!!...

 

beautiful!!!!! everything looks so nice and pretty
update us with the numbers it puts down!!!


chris

 

Hah..you and I must be on the same time schedule bro. Ive had my 93 CX for 6 months now....just got my built gsr motor in my hatch(sans turbo). I still have to buy injectors/DP and BOV before I can put my 60-1 on. Your stuff looks really good dude...those sleeves rip. Let us know how it turns out....

P.S. I have 108 miles on mine

 

I hate you too!! ..
damn that is SO NICE!

 

its a polished max rev.

see more pics here

 

how much and where can i get a PWR ic from?

 

yummy!

 

Looking real good. Cant wait to hear how she does on the dyno.

 

Nice setup man good luck on the dyno !

 

time to tune HI boost.

 

badass

 

i want to see a dyno sheet and a time slip

 

congrats dan, i have been one step behind u for a long time but i think im about 10 steps now. the set up looks great man.