i have a 94 hatch si and i have sitting in the bay area, a j-spec b16a. the problem is that the mount in the middle(in the back) doesnt fit right. i got the swap from HMO and it does look like the mount is suppose to be for the B16a, it just doesnt reach. also, the mount bracket on the engine for the a/c doesnt fit the a/c bracket. and also, i have the lower hose from the fuel pump that doesnt go anywhere? it went to apart of the intake manifold on my old one, but the b16a doesnt have that plug. any help would do!! thanks

 

try mounting the motor from the rear mount first and working with the tranny mount/driver mount later on.

The rear mount is always a pain in the ***.

as for the Fuel Pump line, that goes to your FPR, then from the FPR to the I/M.

as for the a/c, i am not exactly sure what you're asking on that. You might have to get pics or specify more in order to help u out.

 

thanks for the reply, we tried mounting it from the back first, but the engine wont reach the two side mounts if we do that. as for the a/c, on the engine, there is a mount bracket for the a/c to be screwed into, the thing is that the a/c i have, (the mount on the a/c) is a little smaller than the bracket on the engine. what am i to do?