Can you guys please post pics of how the rear fits. i am particularly interested in seeing the bottom part of the seat (The one you sit on). Does anybody have pics of how it fits in the rear. Thanks


[Modified by 1.8 HB, 9:41 PM 9/16/2002]

 

 

Ok my friend bought gsr seats off a '97 gsr. Front seat fit (3 bolts) and the rear, well the part you lean on fits, but the bottom part has a lot of space between the end and the plastic on the side, like the seats (bottom part that you sit on) aren't long enough to cover the whole car from side to side.

 

There is a small gap on the sides, but the gap between the back and bottom was fixed with some padding. Bath towels work pretty good But I used carpet padding.

 

sorry, not really a great shot of the rear seats, but thats all i got for now. the bench will have gaps on either ends, but the middle space is easily fixed with like tonyxcom said with towels

 

couple more pics of grs rear seats in an ek

 

this might help you out.

http://patriot.net/~merritt/tech.html

 

I didn't know that you had to drill some stuff out.

 

YOU DONT. Dont follow Merritt's directions! That is a janky way of getting them in.

Just swap the Integ cushions to your Civic frames. Just unhook all the hog rings etc and swap them over. They will bolt in like stock. Line up like stock. And fold down like stock.

 

Butta.

Ryan

 

yup

 

Dont take it so personal, we have had this conversation before.

You say you didn't want to mess up your brand new stock civic seats...
From your site.
You can't put the stock seats back in anyway now...unless you put them on integra frames

From your site.
That is the only part that I find "janky". And I remember you telling me you made a rod to hold the middle of the seats.

And for the record. Swaping seat frames is reversable. There are no permanent modifications, and you do not harm the upholstery or cushion in anyway during the swap.

Drilling holes in the seat brackets is not reversable

 

I have RSX type S rear seats in my 92 Si and they fit better and look better then the GSR seats.

 

I don't care about putting the stock seats back into the car. Besides I don't think your point holds true anyway. Just because the holes for the seat pegs are slightly enlarged doesn't mean the stock seats won't still work in the car. You can do things your way and have a pile of crap left over in the end. However I like my way since the stock seats remain functionable. You never know when the people that get over zealous and rip out all their interior what some nice clean rear seats again.

 

do you have any pics of that? it sounds pretty bad ***

 

I guess you dont remember that the hole you drilled out was threaded to bolt the bracket that holds the seat. But you are right, you could always put a helicoil in there.