what should i do if i want to remove atts..can i put a base tranny on my sh? what do i need?? can someone help me out...thanks...

 

Here's one link. There's a lot of info about all that in the Prelude Forum FAQs.

https://honda-tech.com/zerothread?id=762014&page=5

 

Skunked5thgen just did it in his car. Hes now running a complete EuroR swap and OBD1.

 

Euro-R has no ATTS. So I suppose that's a pretty good non sequitur.

 

if you dont mind me asking why do you want to get rid of your ATTS?

 

while running any type of engine management except greddy emanage atts will be be deactivated. Therefore Its basically dead weight.

 

just do the following:
1) base model tranny
2) intermediate shaft
3) new driver side axle ony

and ur going to have to make a custom plate.

 

is that intermediate shaft come from the base? and is that custom plate that would cover the atts location?

 

^
yes and yes

 

why not use the SH intermidiate shaft? I wen to some threads and they just mention intermediate shaft but did not say from SH or Base.
Also, it looks like the there is two bolts attached to the plate from the shaft, is that part of modification that needs drilling? This can only be done when block is out right?

Pirate can you answer this.. and how much you selling the plate?