i recently picked up a set of the OEM rear valances without hardware, i was curious what you guys used as 'hardware' for the installation. the instructions list the parts i need, but if anyone who's done this elaborate more on the diameter/thread pitch etc. of the following (listed in the oem directions):

-2 square head bolts
-2 adhesive washers
-4 spring nuts
-4 self-tapping screws
-4 washer bolts
-2 cap nuts

there is no mention of this in the archives that i could find, only one thread that doesn't mention the specific pieces used. not surprising, the parts department at the local dealership was of no help. if all else fails, i'll have to resort to bring the valances inside home depot and spend the afternoon trying out a bunch of different ones until i get the right ones

 

I think I got a mudguard screw after losing one of mine and it fit fine except the washer was bigger than the others. For the square head it might be easier to bring it into Home Depot to test fit it unless someone knows off hand.

 

Trying to remember what you had to do to install these. I know you had to drill a hole in the bumper. Didn't know that until I was about to finish installing the bodykit.

So, all you have is the rear pieces and nothing else?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by RuskeR &raquo;</TD></TR><TR><TD CLASS="quote">So, all you have is the rear pieces and nothing else?</TD></TR></TABLE>yeah, i contacted the guy i bought them from, but i believe he had a body shop do his, so they didn't come with the oem hardware

 

bump

 

oh well, i'll go find out myself i suppose and post up the results so someone can have this thread for future reference