So far my best 1/4 mile time is a 14.4@98mph with the following mods(this is at over 4000 feet above sea level and 90 octane gas, the highest available here)

AEM intake, DC 4-2-1 1 piece header, DC cat back, AEM adj cam gears, B&M fuel pressure regulator, UR crank pully, TODA flywheel, ACT street strip disc / HD pressure plate, JDM final Drive, C's short shifter, spoon 1.35 bar radiator cap.

I am going to replace the DC header with a JDM ITR header and install a car sound cat and apexi N1 cat back. Also going to install a set of TODA Spec A cams and TODA cam gears. Do you think this will get me into the 13's at this elevation?

 

you should already be running 13s - go to sealevel and find out I forget the formula for converting elevation to times and stuff, but maybe someone else knows

 

i think its possible...it'll be hard though. I don't think toda spec A cams are much better then your stock ones though. If you tune your car on the dyno, things will look much better for you

 

90 octane - **** i would have tapped out already if that were the case here...

more power too ya

 

Get spec B's. I have a setup similar to that and I run 12.9's

 

TurboITR, yeah it sucks! I am origanly from MD, i miss good ole SUNOCO 94! Hell i miss alot of things, MIR, E-town, damn i need to move back to the east coast. But untill then i am stuck with 90.

 

you should hit 13' no problem

GOOD LUCK

 

hmmmm whats your setup???

 

AEM cam gears
AEM CAI
Holley FPR
OBD 1 ECU w/Skunk2 program and jumper
Portflow retainers + inner valve springs
Toda spec B cams
MSD wires
Apex VAFC
Spoon header (had JDM 4-1)
Clutchmasters stage 3 clutch
13" Lenso's with 22x8x13" slicks

Ran open exhaust (I have the Apex N1 though)

 

Just curious, how much whp do you make with your car?

 

A hair under 200.
Will dyno again within a few weeks.
I'll post up the graphs.

 

damn nice setup/time

some graphs would be dope