whats the right way to install the wire clips for injectors in obd2
#1
New User
Thread Starter
Join Date: Jul 2001
Location: Long Island, ny, usa
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
whats the right way to install the wire clips for injectors in obd2
i got my injectors today and im putting them in tomorrow, i was just wondering where is the best place to splice into the wires for the injectors? how did you guys do it?
#2
Trial User
Join Date: Jun 2000
Location: Centreville, VA
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
Re: whats the right way to install the wire clips for injectors in obd2 (chuckd05)
i left a few inches on the RC wire clip wires.. finished product looks like stock
#3
Trial User
Join Date: May 2000
Location: Los Angeles, CA
Posts: 7,033
Likes: 0
Received 0 Likes
on
0 Posts
Re: whats the right way to install the wire clips for injectors in obd2 (adam)
line the clips up with the wire clip part facing up... solder and shrink wrap them after you match up the wires from the old one.. also with it's clip facing up.. and wire the wires.. left one on the left one of new clip and right one .. etc... the new wires are both black so you have to liine both clips up and match up the wires with each side... do one at a time so you dont get in a rush...
degraded did mine and it took about 1/2 hour - 45 minutes
easy install if you match upthe wires...
degraded did mine and it took about 1/2 hour - 45 minutes
easy install if you match upthe wires...
Thread
Thread Starter
Forum
Replies
Last Post