ok, i figured i would get some feedback on my setup. its sits now untuned. we only threw it on the dyno to make sure i had enough fuel to race it.

KEY:
blue line- only CAI
red line- as it sits but with a stock bottom end and stock header/exhaust
green line- as it sits but with stock header/exhaust
purple line- as it sits now untuned
here is the graph.


Engine-
- Hondata s200 w/ datalogging
- NGK plugs
- NGK wires
- Generic Front Strut Bar
- B&M Fuel Pressure Guage
- 96 P&P Head
------ Crower Springs
------ Crower Retainers
------ Bronze Valve Guides
------ Crower 62404 Cams
------ AEM TruTime Cam Gears
- B18A Block
------ Bored to 81.25mm
------ USDM B16 Pistons
- BBK 70mm Throttle Body
- Skunk 2 Intake Manifold (port matched to the TB)
- RC 440 Injectors
- AEM Fuel Rail
- AEM Fuel Pressure Regulator
- Greddy 2 piece header
- Test pipe

- Custom YS1 tranny with b16 ratio'd gearing (Not b16 gears, just final result was that of a b16 tranny)
- Exedy Organic Full Face clutch
- Skunk 2 Short Shifter


Modified by sucka306 at 9:16 AM 10/28/2004

 

man...i can see the graph but the lines are sooo thin and lite i can BARELY see it.

 

Can't see **** captain.

 

i see numbers but no lines. doesn't really help since we can't tell what your powerband looks like.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by shermanyang &raquo;</TD></TR><TR><TD CLASS="quote">i see numbers but no lines. doesn't really help since we can't tell what your powerband looks like. </TD></TR></TABLE>

I concur.

 

 

i see the HP and torque numbers but no lines on that graph

 

yeah i know. bad scan. i am going to scan again tomorrow. maybe later tonight. dont know.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by DFW &raquo;</TD></TR><TR><TD CLASS="quote"> </TD></TR></TABLE>

 

updated the pic

 

nice #s.

how does it run in the 1/4?

 

is that a ls if so that pretty damn good bet it pulls like a bitch..

 

yeah, its an LS. i like it. i'm happy with it

no 1/4 yet. only 1/8, but i was having a terrible day and couldnt shift. then i broke my axle.
minor setback now too
https://honda-tech.com/zerothread?id=1037927