I have a 94 4 door civic sohc non vtec(D15) and going to swap it for a D16Z6 but need to know how to hook up the wiring to activate the vtec.
Any help would be appreciated

 

Motor iam swaping came from an auto civic do i need 5 speed ecu?

 

Wire the VTEC solenoid and VTEC pressure switch to the pins on the ECU. You don't need to wire in the knock sensor since you don't have one.

 

i belive you have a p06 and would need a p28 for vtec

 

wow thats some good info thanks

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by eg8tuner &raquo;</TD></TR><TR><TD CLASS="quote">i belive you have a p06 and would need a p28 for vtec</TD></TR></TABLE>

You can get the p06 chipped for vtec.

 

great info!

 

doesnt he also need the intake manifold from a manual for this swap as well?

 

where did u get that pic of the wires

 

www.tiiite.b16a.com

 

You can use an automatic P28, but you will throw a CEL for the automatic transmission lockup solenoid, you can convert the ECU to a 5 speed quite easily though, see pic below



No. Automatic D16Y8s have a different Intake compared to the manual version. All others are the same regardless of transmission.

technet.ff-squad.com

 

I got an auto po6 to chip, do I need to disable the auto stuff just like the p28 or do I need them for vtec?

 

hi guys i need help i have a jdm ecu honda h22a P13 automatic it has 4 socket and i really dont know which is for i want to know the wiring diagram from ecm to sensors if there photo will really great it will make my life easy thank any info it will be great for me

 

Extra fourth plug is for the automatic TCM.

 

ok i need a lot of help and i have a lot of ?'s. sorry. i have a 98 civic coupe which im assuming is obd2a. i bought the car with no motor and the wiring harness to the engine cut. im dropping in a 0bd1 b16 with gsr cams and so im going to run an obd1 p72 ecu. ive got a jumper harness for the ecu to plug in the car. the car was origonally a d16y7 so i have to run the vtec wires to the ecu. so can i just splice the vtec wires into the jumper harness? ive got an old gsr obd1 harness that i will b using the injector dizzy and alternator plugs. will the wires match up to a d series obd2 civic engine harness?im going to solder all the connections at the cut point and use shrink wrap. i just want to make sure the extra sensors on the d series that wont b hooked up will not effect the way the motor runs.
And the ultimate question... is there an easier way to do this that wont cost me hundreds of dollars just to hook everything up?

thank you and please help!!!! i dont want to use the guess and check method on this one.

any help will b appreciated

 

Use a 96-98 civic ex harness