ok so im swapped a k20 R motor into my ek..swap and wiring was done..tried to start the car up but wont. the car will crank. my ek was an auto before. so thinking that swapping the dash harness to a manual would work. after swappaing the manual dash harness tried to start it up but still wont. btw the fuel pump will only prime if u hard wire it even before swapping dash harness. swapped a new engine harness and tried to start up the car and the problem is still there. the kpro isnt getting power. im running the hybrind racing pnp harness updated. what could this problem be? grounding or bad connection since the car go repainted??