just want to double check my igniter wires are wired to the correct spade terminals .
does anyone have a good diagram as to which wires (+) (-) trigger and tach go to position wise on the igniter?

from memory i believe that with the igniter installed in the dist the tach goes to the single spade on the side of the igniter
the top spade it the trigger to the coil
middle spade is the (+)
and the bottom spade is the (-)

can anyone verify this is correct or provide some input or diagrams
i have a honda shop manual but it does not give accurate spade positions

by the way its a obd1 dist