I have a motor i got from this guy i know. It is a d16y7 bottom end, and a d126z6 head with a dx intake manifold. I am using obd1 b16 injectors cause they were all i had. The car is a 92 civic dx. And i am running the p06 ecu. The car ran for a few yesterday, but the intake manifold gasket wasn't sealed right, so i took it off and replaced that, and when i was finished, it ran for a few seconds and now it won't run at all. it won't even start?

 

anybody care to chime in?

 

you gotta wire in the resistor box if you are gonna use those.

 

why is that?

 

oops i fugged up. you will be fine. i didnt see that they are obd1. my bad