How should i sell my car??
I need to sell my hatch and im not sure if i should sell it as a whole car or part it out. THe engine is fully rebuilt and only has like 4500miles on the engine, im not sure if its worth taking it apart to sell......im selling the car because i need something more practical for school........if you had any experience with this let me know how it turned out....thanks
Its a 96 ek hatch
exterior:
has a few scratches and dings
ctr headlights, carbon fiber hood with locking hoodpins
carbonfiber spoiler
carbonfiber grill
ctr front lip
tokico illumina adjustable
ground control coilovers
skunk2 camber kit
black gsr blades
Engine: balanced, cleaned and flushed blueprinted and resembled
b18c hasport engine mounts
brand new parts installed
jdm spoon balanced pistons, with type r rods
skunk 2 valvetrain
stage 2 cams, titanium valvesprings, retainers, valves
dpr stage 5 head with rocker arms lightened
skunk2 intake manifold, portmatched 68mm holley throttle body
j's racing intake with k&n filter
brand new distributor, IACV, and FIV
rc 310cc injectors
255lph
aem fuel rail and presure regulator
fluidyne radiator
mugen thermastat with switch
headertech custom header stainless steel
custom 2.5 exhaust mandrel bent
hondata s200
fully tuned with dyno sheet
194.7hp, 121tq
dynapack with 5hrs of tuning
Interior
bride exasIII fiberglass seat with bride lumbar, headrest, knee pads
passenger sparco torino seat
takata harness
sparco lap 5 wheel
civic si guage with carbonfiber layout
dual bezel guage pod and single arm pod
oil pressure, air fuel, water temp
tranny
gsr tranny
clutchmaster stage 3 clutch with lightened flywheel
quaife lsd
skunk2 shortshifter with shiftknob
just installed 6/29/04
brand new jdm 4.7 final drive gear set
new syncro set for 5ht and reverse
an alarm system that cost me over 900.00
also i have a custom set of volk racing black te-37's brand new coming from japan
15X7, 4X100 in less than two months, already paid for so i want what i paid for them.
also my carbon fiber hatch will be here in a week(vis), not sure if i want to install it
Im sure there is stuff i forgot but I have all my receipts here to show also a dyno sheet
exterior:
has a few scratches and dings
ctr headlights, carbon fiber hood with locking hoodpins
carbonfiber spoiler
carbonfiber grill
ctr front lip
tokico illumina adjustable
ground control coilovers
skunk2 camber kit
black gsr blades
Engine: balanced, cleaned and flushed blueprinted and resembled
b18c hasport engine mounts
brand new parts installed
jdm spoon balanced pistons, with type r rods
skunk 2 valvetrain
stage 2 cams, titanium valvesprings, retainers, valves
dpr stage 5 head with rocker arms lightened
skunk2 intake manifold, portmatched 68mm holley throttle body
j's racing intake with k&n filter
brand new distributor, IACV, and FIV
rc 310cc injectors
255lph
aem fuel rail and presure regulator
fluidyne radiator
mugen thermastat with switch
headertech custom header stainless steel
custom 2.5 exhaust mandrel bent
hondata s200
fully tuned with dyno sheet
194.7hp, 121tq
dynapack with 5hrs of tuning
Interior
bride exasIII fiberglass seat with bride lumbar, headrest, knee pads
passenger sparco torino seat
takata harness
sparco lap 5 wheel
civic si guage with carbonfiber layout
dual bezel guage pod and single arm pod
oil pressure, air fuel, water temp
tranny
gsr tranny
clutchmaster stage 3 clutch with lightened flywheel
quaife lsd
skunk2 shortshifter with shiftknob
just installed 6/29/04
brand new jdm 4.7 final drive gear set
new syncro set for 5ht and reverse
an alarm system that cost me over 900.00
also i have a custom set of volk racing black te-37's brand new coming from japan
15X7, 4X100 in less than two months, already paid for so i want what i paid for them.
also my carbon fiber hatch will be here in a week(vis), not sure if i want to install it
Im sure there is stuff i forgot but I have all my receipts here to show also a dyno sheet
Thread
Thread Starter
Forum
Replies
Last Post
t00JDM
Florida (Sales)
17
Jun 3, 2011 09:18 PM



