I recently swapped in a B16 in favor of my ZC.
At first it threw code 43, 44 and...code 2.

I replaced my 02 sensors.....
code 43, and 44 are gone...but code 2 is still here!

WTF?!?!

I know the dizzy is a bit wacky wired up... but can't get the torx screws out. Can a dizzy cause a code 2??
It drives even worse then before I replaced the 02 sensors...and I'm pretty sure I wired them up properly.

I'm out of ideas guys...plz help!!

 

No the distributor will not cause that, check your wiring and make sure you have the correct volts that you should have.

 

I must add, that it chokes like a ****. sounds rough, backfires etc... but after 4000Rpm or so, it gets better.

 

Sounds like the ecu is not getting a reading from the 02 sensor, check the wiring.

 

will do... 23:15 now... first thing in the morning.
This is pissing me off badly

 

Yesterday I retraced all the wires. Turns out, that one of the sensors was hooked up wrong. It's not a n OEM denso sensor, so the colors were off. I simply soldered the wires in in the wrong order.

D'OH!

Thanx for the help.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by SETI20 &raquo;</TD></TR><TR><TD CLASS="quote">Yesterday I retraced all the wires. Turns out, that one of the sensors was hooked up wrong. It's not a n OEM denso sensor, so the colors were off. I simply soldered the wires in in the wrong order.

D'OH!

Thanx for the help.</TD></TR></TABLE>

Your welcome, glad I could help, if you have any more problems feel free to IM me.