Need a Q answered ASAP!!
Thread Starter
Junior Member
Joined: Aug 2002
Posts: 424
Likes: 0
From: Land Down, Under, Australia
Need a Q answered ASAP!!
I got JE 89mm 9:1 pistons being put in a set of darton sleeves.
My machinist thinks that the 4 thou spacing that is reccommended by darton is a little too small.
Can anyone confirm that it is 4 thou?
Thanks in advance!
My machinist thinks that the 4 thou spacing that is reccommended by darton is a little too small.
Can anyone confirm that it is 4 thou?
Thanks in advance!
Honda-Tech Member
Joined: Nov 2002
Posts: 3,969
Likes: 6
From: northern DRUNKit, ma
Re: Need a Q answered ASAP!! (satan_srv)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by satan_srv »</TD></TR><TR><TD CLASS="quote">what spacing are you talking about? Piston to cylinder?</TD></TR></TABLE>
yeah i think he is talking about piston to cylinder clearnce
yeah i think he is talking about piston to cylinder clearnce
Thread Starter
Junior Member
Joined: Aug 2002
Posts: 424
Likes: 0
From: Land Down, Under, Australia
Re: Need a Q answered ASAP!! (prelittlelude)
sorry Should have been more specific.
I am talking about the piston to cylinder clearance.
So does anyone know what it should be??
I am talking about the piston to cylinder clearance.
So does anyone know what it should be??
Thread
Thread Starter
Forum
Replies
Last Post
Leo.
Forced Induction
4
Dec 8, 2006 02:56 PM
Gant
All Motor / Naturally Aspirated
3
May 28, 2005 08:10 PM