Swapping A6 and A11 ecu pinouts for H22 swap.
Thread Starter
Honda-Tech Member
Joined: Dec 2002
Posts: 1,179
Likes: 0
From: OK
Swapping A6 and A11 ecu pinouts for H22 swap.
I have had my H22 swap for almost two years now and I still haven't switched the A6 and A11 wires after the swap. The check engine light comes on after 30 minutes of driving. Yesterday, I decided to swap the two wires, but my obd2 to obd1 conversion harness doesn't have an A11 wire! I was kinda stunned after seeing that.
So my question is, does anyone on H-T know which wire on the original obd2 harness is heater (A11 on p13 ecu) wire?
I am just going to plug that wire directly into the p13 ecu. Thanks in advance. I hope someone can answer this for me.
PS: I found this: http://importnut.net/h22a_swap.htm and in the chart, A11 for a '93 Prelude is A7 for an OBD2 Accord? Thanks again.
So my question is, does anyone on H-T know which wire on the original obd2 harness is heater (A11 on p13 ecu) wire?
I am just going to plug that wire directly into the p13 ecu. Thanks in advance. I hope someone can answer this for me.
PS: I found this: http://importnut.net/h22a_swap.htm and in the chart, A11 for a '93 Prelude is A7 for an OBD2 Accord? Thanks again.
Thread
Thread Starter
Forum
Replies
Last Post
HAccord96
Hybrid / Engine Swaps
10
Apr 16, 2004 12:22 AM
