recently my chk engine light came on (92 prelude with 1995 h22a v-tec swap) i trouble shot the code for the light came up code 9. So i tracked down the 8 pin harness on my distributor and tested for the 700-1300 ohm resistance. Most were nill and a few were 5 ohms . So it seems i may have a toasted ecm. I had the chip in the ecm as well.
Is there a certain computer i should buy? and is there one i can buy cheap that is already chipped? If i have to buy one id like a few suggestions on a reliable one. ty

mike