milling head to increae b16 CR from 10.2 to 11.07
Thread Starter
Joined: Mar 2002
Posts: 1,883
Likes: 0
From: Kelowna, BC, CaNaDa
milling head to increae b16 CR from 10.2 to 11.07
im going to increase the cr ratio by a small mill to make sure the deck and the head surface are flat and use a 1 layer headgasket. i calculated it that it should be around 11.07 cr.
im just not sure what cams to go with this setup, what valve train. and how much power i should be expecting by jsut the mill.
this is milling the head by .007 of an inch and usuing a .0096 think headgasket
Thanks Tory
im just not sure what cams to go with this setup, what valve train. and how much power i should be expecting by jsut the mill.
this is milling the head by .007 of an inch and usuing a .0096 think headgasket
Thanks Tory
Thread
Thread Starter
Forum
Replies
Last Post
No
All Motor / Naturally Aspirated
33
Jan 12, 2005 04:44 PM
RICE POLICE SIP
Honda Civic / Del Sol (1992 - 2000)
10
Mar 29, 2003 09:20 PM