EG cx hb w/ LS swap...how to accept 4-wire O2 sensor???
Thread Starter
Junior Member
Joined: Oct 2001
Posts: 657
Likes: 0
From: Arlington, TX, USA
EG cx hb w/ LS swap...how to accept 4-wire O2 sensor???
for you guys with LS powered EG cx's...just wondering how you got wired your 4-wire O2 sensors??? did you have to get a new engine harness or what?
Re: EG cx hb w/ LS swap...how to accept 4-wire O2 sensor??? (curiousgpnoy)
O2 sensor (CX only) add 3 wires to O2 sensor and follow o2 wires and change to Integra O2 sensor connector. And wire the following:
- WHT/RED wire goes to D14 which is O2 Sensor Input
- ORG/BLK wire goes to A6, which is Heater Control
- GRN/WHT wire goes to D22 which is Sensor Ground
- YEL/BLK wire goes to A25 which is Sensor voltage
- WHT/RED wire goes to D14 which is O2 Sensor Input
- ORG/BLK wire goes to A6, which is Heater Control
- GRN/WHT wire goes to D22 which is Sensor Ground
- YEL/BLK wire goes to A25 which is Sensor voltage
Thread
Thread Starter
Forum
Replies
Last Post
Markb16a
Honda Civic / Del Sol (1992 - 2000)
2
May 13, 2007 08:26 PM
slwazgsr
Acura Integra
1
Oct 17, 2002 06:53 PM
