The manifold. New, never used. A fine example of some creative work by Tinker219. Thick wall stainless steel, equal length, flanged for a 40mm Tial wastegate.










The GT37 is new, never used w/82 mm compressor wheel. Good for about 700hp according to Precision. Some pics of the turbo-





Turbo goes for $1K+ at Precision, and the manifold is quite a piece of work and wasn't cheap.
$1850 shipped.

Thanks
Ben

 

how much you want for just the turbo? also why you getting rid of it?

 

I'd rather sell together...the manifold and turbo have a divided housing so they are essentially built for each other.
Selling to buy a smaller turbo. The car is for the One Lap of America race and after checking out the tracks I decided that I needed something smaller.
BTW- this setup clears Jimfab traction bars in an EG (barely) so you won't have any problems if you have traction bars.

Ben

 

i have a smaller turbo to trade if you see that you cant sell the set then , Lemme know if you change ytour mind .
i have a t3/04e 60 trim , 82ex housing
top end is rediculous and spools uner 3500 and full spool about 42-4300
itsa a great turbo i just need more flow.

 

up....

 

make offer....

 

up...

 

thats a nice looking manifold...where did it come from and what motor was this runnig on.....i want to know if it was fully built and how much hp you were making...or planning on making

 

Motor is fully built, but the mani/turbo was never used.
Was planning on making 600+ hp on a 2L B18C with decent spool.
Manifold was made by Tinker219 (www.lovefab.com). Good stuff.

 

up.......

 

$1700 shipped.....

 

wheres the DP?

 

Downpipe is in my garage, I didn't have any pics of it handy and I've been away at work for a few weeks.

 

up...

 

What size is the downpipe?

 

3" downpipe.

 

Are you sure about the equal length manifold? The first and fourth runners don't seem the same length?

 

Like any "equal length" manifold, there is a small difference in runner length.

Anway, looks like this package is sold....

Ben