Narrowban O2 sensor hookup
Thread Starter
Joined: Nov 2003
Posts: 11
Likes: 0
From: gilbert, az, usa
Narrowban O2 sensor hookup
I have a 00 Prelude non-SH and have just bought a standalone o2 sensor.
The controler have output (signal and ground)
I'd like to install the new o2 sensor and hook up the NB output to the stock ECU.
Looks like it should be going to D7 and D12...
Does anyone know if this is the correct pins to hook up the NB wires?
Your help is greatly appreciated.
The controler have output (signal and ground)
I'd like to install the new o2 sensor and hook up the NB output to the stock ECU.
Looks like it should be going to D7 and D12...
Does anyone know if this is the correct pins to hook up the NB wires?
Your help is greatly appreciated.
Thread Starter
Joined: Nov 2003
Posts: 11
Likes: 0
From: gilbert, az, usa
Re: Narrowban O2 sensor hookup (GudeH23a)
I bought a wideband with controller. The controller have narrowband output.
I'd like to use the new sensor but connect to stock ecu so I have to connect the NB output to NB input of the ecu.
Hope I made that clear.
I'd like to use the new sensor but connect to stock ecu so I have to connect the NB output to NB input of the ecu.
Hope I made that clear.
Thread
Thread Starter
Forum
Replies
Last Post
Perfectionist
Tech / Misc
1
Oct 20, 2006 03:36 PM