skunk2 shifter install
Thread Starter
Junior Member
Joined: Nov 2003
Posts: 16
Likes: 0
From: Richmond, VA, USA
skunk2 shifter install
I have a question for anyone that has the skunk2 shifter installed.
I found the topic that has the layout of the shifter, bushings and spacer at https://honda-tech.com/zerothread?id=674940 where they talk about the order in which the spacers and stuff go in. Well, I was installing the shifter last night and found that the spacer is too big! I've pretty much pounding in the smaller spacers as much as possible into the shifter itself but still not enough room. Anybody else had this problem before or any suggestions on what I should do?
I found the topic that has the layout of the shifter, bushings and spacer at https://honda-tech.com/zerothread?id=674940 where they talk about the order in which the spacers and stuff go in. Well, I was installing the shifter last night and found that the spacer is too big! I've pretty much pounding in the smaller spacers as much as possible into the shifter itself but still not enough room. Anybody else had this problem before or any suggestions on what I should do?
Thread
Thread Starter
Forum
Replies
Last Post
slkleltlclh
Honda Civic / Del Sol (1992 - 2000)
6
Jul 21, 2006 09:44 PM
