i was putting my rings on earlier(itr pistons) and the rings minorly scuffed the sides of the piston, enough so that i can see it...i'm wonderin if there was a proper method to sand the sides of the piston to insure a smooth surface? any help would be appreciated. thanks.
(pics suck but the scuff is by the pin)





Modified by eghonda at 8:59 PM 11/6/2003

 

since they are on the side if the piston,you shouldnt have a problem.I hope your using a piston ring installer....

 

Take a little emry cloth to it and it will be fine.

 

emry or just leave it