Head Port and Polishing???????
Thread Starter
Honda-Tech Member
Joined: Mar 2001
Posts: 1,550
Likes: 0
From: San Luis Obispo, CA
Head Port and Polishing???????
Has anyone went through PortFlow? I want to send my head out to get some work done to it. What's their price range and how good of work do they do? How much power does it add? can someone please let me know.
Honda-Tech Member
Joined: May 2001
Posts: 3,795
Likes: 1
From: San Antonio, TX
Re: Head Port and Polishing??????? (On Point)
PORTFLOW IS GOOD..... ABOUT PIRICE I GOT NO CLUE BUT A LOT OF PEOPLE ON THIS BOARD HAVE GOTEN WORK FROM THEM
Honda-Tech Member
Joined: Jan 2000
Posts: 886
Likes: 0
From: MA
Re: Head Port and Polishing??????? (01GSR)
Hi Portflow did my head.
Milled it 20 thousandths, tanked it, and gave it a nice PnP.
Cost is ~$750 I think.
I'm not sure on gains, I'm actually dynoing on Sat. Old setup made 173 HP and 124 TQ at the wheels.
Lots of new goodies, so I should be significantly higher...
If you are going all out N/A or FI, good headwork will usually be one of the main contributors for power.
FB
Milled it 20 thousandths, tanked it, and gave it a nice PnP.
Cost is ~$750 I think.
I'm not sure on gains, I'm actually dynoing on Sat. Old setup made 173 HP and 124 TQ at the wheels.
Lots of new goodies, so I should be significantly higher...
If you are going all out N/A or FI, good headwork will usually be one of the main contributors for power.
FB
Thread
Thread Starter
Forum
Replies
Last Post
