(skunks2 Camber kit) How Low Was Your Car??
Thread Starter
Member
Joined: Dec 2001
Posts: 1,333
Likes: 0
From: Throwin up the W
(skunks2 Camber kit) How Low Was Your Car??
Well Post in the Integ Forum no repsones so I thought I would try here
Well I Have Just Recently Purchased... a Skunks2 Camber Kit I have read alot about people tearing the ball joints cause there car's are to low my questions is how low is to low.... currently I am Driving a 96 LS sitting on H&R Race springs... which are 2.25" I am rolling on 16" Rotas. Also I have been reading about people using polyurethane ball joint covers where can i pick these up??? An will they save the ball joints??? cause i am kind of hesistant on puttin these on thanks peace
Well I Have Just Recently Purchased... a Skunks2 Camber Kit I have read alot about people tearing the ball joints cause there car's are to low my questions is how low is to low.... currently I am Driving a 96 LS sitting on H&R Race springs... which are 2.25" I am rolling on 16" Rotas. Also I have been reading about people using polyurethane ball joint covers where can i pick these up??? An will they save the ball joints??? cause i am kind of hesistant on puttin these on thanks peace
Thread
Thread Starter
Forum
Replies
Last Post
allmotorEG-SI
Honda Civic / Del Sol (1992 - 2000)
7
Jun 12, 2003 12:00 PM
