I just replaced the rear pads on my 91 CRXsi. I had a LOT of troubles with the job, and I ended up taking off the calipar. I put them back on, and tried my best to bleed the breaks properly, but they still seem a bit "squishy".

Perhaps there is still air in the line.

Can somebody please give me a detailed step-by-step explanation about how to bleed break systems?

 

right front, left rear, left front, right rear, thats how youo bleed them, you also tighten the bleed bolt in mid stream

 

straight out of my honda shop manual:

 

Good info....I need to change my stuff soon....