I have a Sparco Sprint seat custom installed in my 94 Civic Hatch. It does not slide. Where would the best points be for my Sparco Clubman 3 point harness be? The main problem is the left (closer to the door) and rear point. I'd like to have the rear one centered behind the seat. Could I weld some 1/4" steel under the car between frame points and bolt them through that? Any ideas? Any pictrues of what you guys have done? Thanks

 

read the safety installation instructions.....almost all harness belts must have no more than a 40 degree turn from the back of the seat!

 

On your Roll Bar/Cage.