I have a 200+whp lsvtec with zero miles on, block is a b18a with a knifed crank, was bulit by Ericks Racing in Torrance Ca. has B18b rods, ITR pistons, B16 head built by Portflow has CTR cams ITR valves, Portflow inner and outer springs and titanium retainers, RC 270's, PYR crank pulley, RPM service billet flywheel, ITR oil and water pump, new GSR timing belt, head has been milled and ported to Ericks and Toms specs, motor has all new seals and gaskets, new timing belt tensioner, also have a B16 cable trans.

I am looking to trade for a GE sleeved block with some crower rods and je pistons, must have zero miles and have all paper work showing who built it. I will consider making deals, will even sell the motor straight up if anyone is interested.

 

bump

 

sorry man, highly doubt you maye get an offer ... I have a fully built ls/vtec block with Endyn pistons and Eagle rods and have a hard time trading for a sleeved block.

good luck anyway

 

thanks i'd figure i'd give it a shot, i'd consider also trade plus cash on my side