My 3 seconds of fame in DRAG magazine...
Well after many years, there is finally a picture of my car in a magazine. Drag magazine January/February 2003 page 61, the white hatch in the upper right hand corner. Too bad I sold the damn car
The track conditions were great that day and I ran consitent 12.40's all day. Same day Jason ran 9's
[Modified by SIKCX, 6:32 PM 1/20/2003]
The track conditions were great that day and I ran consitent 12.40's all day. Same day Jason ran 9's
[Modified by SIKCX, 6:32 PM 1/20/2003]
tony is in the last 2 or the last one then skipp one and hes in the next
but i know theres 2 pics of tony
but hey you know there is pics of tony all over the us
wehn kids take a pic of the hsops car, tony is usually there working on it
i have on of those
but i know theres 2 pics of tony
but hey you know there is pics of tony all over the us
wehn kids take a pic of the hsops car, tony is usually there working on it
i have on of those
Trending Topics
hey tony idont have a copy of that drag magazine but i saw it, I can't remember if that was a box of JE pistons on the bench in the back ground when you were assembling the bottom end. whick leads me to the next question. some where you said you were using ARIAS pistons? does my memory serve me correctly, I am on the downward slide to 30 now
I am sure he uses the arias. I see him all the time when he is building these monsters over there... pretty sure he using arias with aebs sleeved block or rs machine blocks with bce heads.
i'm showin my age,
, just saw it. now i am trying to figure out how I spelled Arias with a J and an E. I guess I am not perfect after all. lol
, just saw it. now i am trying to figure out how I spelled Arias with a J and an E. I guess I am not perfect after all. lol
Just stand by lisa all the time and your bound to end up in the background of a pic
We have a couple of RS blocks, but we are only running the AEBS blocks this year in our race car. The RS blocks are going in customers cars and a street car i'm building.
Thread
Thread Starter
Forum
Replies
Last Post
Teglove2
Welding / Fabrication
7
Feb 15, 2012 03:48 PM




