Hey, I am new to the boards and was wondering if any of you guys have tired this? I understand that it is not a direct fit. There is about a 1 inch gap on the sides of the seats which I am cool with.

I would like to know how did you guys, if anyone has tried this, bolt them in? The OEM Honda seats are a 60/40 fold where as the Type R seats are a 50/50 fold. This would mean the the seat will not fold down once installed. This is no problem. Just want away to make it secure enough so that If someone does decide to sit in the back they will not fall down. I do use my trunk, minimally, but whatever you guys can think of or reccomend I would greatly appreciate.

~Mike

 

I wouldn't do it. If you want the Type R look, get yours reupholstered

 

i dunno about 96-00 but 93-95 coupes should use 94-01 integra SEDAN rear seats. 92-95 civic hatches can get away with 94-01 3door seats

 

Whats the matter? No Faith? I have seen it done just wanted to get pointers. I am going to do it. I am determined. I just wanted to see if any of you "honda-techies" have done this.

 

Is this the guy who bought my rears?

 

this is "that guy" hahaha.. The guy that had the directions for me has been too busy to get em over to me. What can I tell ya... I was trying to get some more opinions on "Tips and Tricks" haha thanks again for the seats though. Have you got the M.O. yet?


[Modified by EggEX2000, 7:05 PM 1/18/2003]

 

.....subscribing to this thread since I think it's possible as well - just how much trouble is it?