Do Skunk2 stageII cams have a rough idle??
I have a 01 ITR with AEM CAI, DC JDM header, Apexi N1 exhaust, Carsound cat, and Chipped p28 ecu. I was planning on buying the skunk2 stageII cams next. I am going to get cam gears, springs and retainers. Is there anything else you think I need?? And do these cams have a rougher idle (loping)??
I personally don't have the S2 stage 2 cams, but I know a few people on here have them and have never complained about a rough idle... in fact they said it was quite a good idle.
Trending Topics
Smooth Idle and sounds bad *** with no exhaust. Just be careful when moving the cam gears.
Smooth Idle and sounds bad *** with no exhaust. Just be careful when moving the cam gears.
Hey MPH, I want your opinion on this.....which cams do you think I should run... with the setup I have? Should I run the stageII cams or the stageI cams? I know you have had experience with both sets I would like to know what cams you prefer?
Hey MPH, I want your opinion on this.....which cams do you think I should run... with the setup I have? Should I run the stageII cams or the stageI cams? I know you have had experience with both sets I would like to know what cams you prefer?
Thread
Thread Starter
Forum
Replies
Last Post
Teamdiesel
All Motor / Naturally Aspirated
3
Jan 16, 2006 07:35 PM
VTEC Visions
All Motor / Naturally Aspirated
49
Sep 3, 2005 11:19 PM
cs_x21
Honda Civic / Del Sol (1992 - 2000)
2
Jun 25, 2003 03:54 PM




