im putting d16a1(88-89 integra) pistons on my d16z6 motor along with 97 integra ls rods i dont know what specs i should get the block done to i have never acually built a motor before and im not shure what specs i give the machine shop.

another question is: do i get the rings for the a1 pistons for the standered bore fore that engine? i know the cc of the a1 is more than the cc of the z6

anything i should know before ordering pistons and takeing my block to get worked?

thnks

-larry

 

lots of info on this at http://www.dseries.org