sup ya'll, im new up in here so take it koo with me aight! so i have a fuked up motor in mah crx, and im about to do a zc swap and need suggestions on what kind of ecu i would need for this kind of swap? just leave a message yo!

 

pm6 (si), pm7 (zc), or pr4 (teg)(? on teg ecu id)

 

You have it right except for people usually use the PG7 88-89 integra ecu with ZC swaps.

 

Also a PG7 which is 88-89 Teg 1.6 DOHC

 

I use the PG7 (88-89 teg). Revs higher and runs better than the Si ECU for me.

 

pg7 all the way, those old skool tegs are in boneyards all over the place---i bought mine for 20 bills.

 

I'm running the ZC ECU(pm7) w/ my ZC swap, and I'm happy w/ it. My friend use to run the teg ECU w/ no problems, so either the teg or ZC ECU would probally be just fine.

 

sup dude u say the pg7 rev higher and runs better, but does it pass smog dude? thanks for the suggestion to man!

 

(I use the PG7 (88-89 teg). Revs higher and runs better than the Si ECU for me.)
did ur car pass smog with that motor and pg7

 

man...you talk hella ghetto yo.....T dawg in dizhizouse be mad stressin over sumz compz yous needz tuh maik yo shietz run ahh motuh terbho! LOL

j/p withca tom......good to finally see you on honda-tech! Roll to chico and visit me!!!!! and quit smoking! your too young!!! lol

 

I have a pm6 chipped with a mugen zc dohc program if you want $100

 

I ran the stock Si ecu for like the first 5 months with my ZC. Ran just fine, but the rev limiter was annoyingly low. Finally upgraded to the Pg7 recently. Honestly I did't FEEL a difference powerwise. But it did raise the rev limit, which was nice.

 

question still is:

 

did that pm6pass smog?

 

does ur car pass smog with that pg7?