Hey guys I have a 95 Integra with an automatic to manual conversion and I am trying to find the correct dust boot to go on the interior under the center console to seal off the hole in the floor where the shifter comes through. The hole is a little larger than what it would be on a typical manual so which boot can I use to close off the hole? Hopefully this makes sense. Would it be #6 which doesn't seem like it's available. Just struggling with what to use here. Hopefully some has some good experience with this.

 

You can get creative and put a plate over the area to cover the hole. Check out my build thread on this page below, I put a carbon fiber plate over this area to cover it and give it a bit of a custom touch when I installed my Hybrid short shifter, First i used a simple peice of card board with carbon fiber vynal then I replaced it with a real carbon fiber plate, They sell the CF plates on Ebay.

https://honda-tech.com/forums/appear...556604/page27/