Swapping over DC2 parts onto EM1
Thread Starter
Honda-Tech Member
Joined: Aug 2018
Posts: 11
Likes: 0
Swapping over DC2 parts onto EM1
I’m looking to purchase a EM1 however here in California I need it to pass smog. The EM1 has a Magnaflow Exhaust and a Password JDM intake on it right now. I have an extra DC2 stock muffler and intake laying around, would they be able to fit and pass CA smog inspection?
Re: Swapping over DC2 parts onto EM1
I’m looking to purchase a EM1 however here in California I need it to pass smog. The EM1 has a Magnaflow Exhaust and a Password JDM intake on it right now. I have an extra DC2 stock muffler and intake laying around, would they be able to fit and pass CA smog inspection?
Fish Twig
Joined: Nov 2005
Posts: 15,554
Likes: 309
From: Still hunting that foo up there
Re: Swapping over DC2 parts onto EM1
Well...it might fit but the dc2 muffler tip will fall short but that depends on if you have the stock b-pipe. As for the intake 50/50 you'll pass visual.
Fish Twig
Joined: Nov 2005
Posts: 15,554
Likes: 309
From: Still hunting that foo up there
Re: Swapping over DC2 parts onto EM1
you have to get an extension between the cat converter and the b-pipe, only then will the curved section of the muffler go over the lca. Done it and all is fine, just the tip of the muffler doesn't extend out to the bumper and is burning it up.
Thread
Thread Starter
Forum
Replies
Last Post