Hello, I just installed a new clutch in a 99 Honda accord and when I was all done I can not get it to move. When I put it into gear the speedometer moves put the car will not. I can hear it sounding like it might be in gear when I rev up but still no movement. I have tried bleeding the clutch also. Any idea of where I went wrong?

 

If the speedo is working the engine is sending power to the transmission.
Clutch install went fine, most likely you have an axle that is not fully seated.

 

I am being told the throw out bearing is not set right. What do you think? Could that be possible?