CT Evo fs or ft
New clutch masters fx200
New Oem oil pan
Inner and outer tie rods
New return gasket
Steel braided return line
Oem filter
Mobil 1 10w30 oil
Alignment
Mishimoto rad
Steel braided clutch line
Cusco 3 point strut bar also has a stopper for movement of brake booster
Alternator was done Oem used tested it and all
before install and new serpentine belt
Jdm rear bumper
7 tails
9 front bumper w/ se lip
Race land coil overs
3" Buscher racing exhaust
Aem wideband
Boost gauge
Jdm double din console
Kenwood in dash
Manley rods
Weisco Pistons
Gsc valve train
Gsc 2 cams
T3 Forced performance Hta 3586
Aem v2
Tial waste gate & bov
3" intercooler and piping
1000cc Id injectors
Ets I believe manifold
All mods are to best of my knowledge and have been confirmed.
I have pictures of resurfaced fly wheel and new clutch being installed.
Made 557+ on break in I've been dailying it for a little
Looking for a jdm itr dc2 or db8 or ek9 so I'm willing to trade or sell for $15,000
Contact @ 860-986-4859 via text preferred
Needs: bumpers painted
Needs power wire to amp
Needs center caps for bbs 9 wheels
And there is very slight leak on valve cover gasket.
Front lip has a thin crack but its easily very fixable
Gas gauge fluctuates sometimes
Doesn't consume oil I've checked on it to make sure
And motor has almost 9k on it.






New Oem oil pan
Inner and outer tie rods
New return gasket
Steel braided return line
Oem filter
Mobil 1 10w30 oil
Alignment
Mishimoto rad
Steel braided clutch line
Cusco 3 point strut bar also has a stopper for movement of brake booster
Alternator was done Oem used tested it and all
before install and new serpentine belt
Jdm rear bumper
7 tails
9 front bumper w/ se lip
Race land coil overs
3" Buscher racing exhaust
Aem wideband
Boost gauge
Jdm double din console
Kenwood in dash
Manley rods
Weisco Pistons
Gsc valve train
Gsc 2 cams
T3 Forced performance Hta 3586
Aem v2
Tial waste gate & bov
3" intercooler and piping
1000cc Id injectors
Ets I believe manifold
All mods are to best of my knowledge and have been confirmed.
I have pictures of resurfaced fly wheel and new clutch being installed.
Made 557+ on break in I've been dailying it for a little
Looking for a jdm itr dc2 or db8 or ek9 so I'm willing to trade or sell for $15,000
Contact @ 860-986-4859 via text preferred
Needs: bumpers painted
Needs power wire to amp
Needs center caps for bbs 9 wheels
And there is very slight leak on valve cover gasket.
Front lip has a thin crack but its easily very fixable
Gas gauge fluctuates sometimes
Doesn't consume oil I've checked on it to make sure
And motor has almost 9k on it.






Last edited by Cycsteez; Dec 22, 2015 at 05:59 AM. Reason: Adding contact #
Thread
Thread Starter
Forum
Replies
Last Post
FS/ Testing Waters: Turboed Benson Sleeved B16 Longblock, NEW ITR tranny, Turbo, AEM PEMS, intercool
andyjt
For Sale
8
Nov 16, 2005 07:37 PM



