I have a 95 gsr head installing the Brian crower BC0010 set of dual valve springs and titanium retainers kit. I know the factory's go with the right coils down toward the seat the BC's don't seem to have a tighter coiled end do you just put them in either way? I've searched and no one seems to have an opinion. Any help appreciated guys.

 

What did Brian crower say when you called them?

I don't recall ever seeing a orientation for spring install on these motors.

 

I couldn't get anyone on the phone I suppose since it's a weekend. I emailed them yesterday also no reply probably the same reason it being Saturday. But I've actually measured them in and mm and seems to be the same on both the big spring and the smaller spring so I've just been installing them however i pick them up. They sit on the seats strange until you start compressing them because they're so much stiffer but once you compress them the keeper and retainers seem to flush up either way. So I'm thinking it doesn't matter

 

The coils that are closer together go at the bottom close to the head.

 

2 weeks after the last post and you didn't bother reading his post. Op says they don't have a tighter coiled end. Looking on their site, they look fully linear.

 

You are right I read his post to quickly...As for the time lapse Im not sure why that matters ..An answer is an answer if it is right and helps.