Hey everyone
Got a call from a fellow shop owner that needed an exhaust system for a Camaro that they are putting together so I took a few tools over and fabbed this up.
All done with sanitary stainless and welded with my HTP 221.
Enjoy

 

any more pics of the headers?

 

Sorry no I do not have any pics of the headers. They were already on the car I only did the exhaust.

 

Good looking big block

Nice exhaust system too man. My chevelle will be running a similar setup (3" w/ xpipe) all stainless.

Should throw up a sound clip when it's running. Curious to hear those Magnaflows.

 

Does the x-pipe open up in the inside?

Can't tell by the pictures

 

Is it supposed to be so asymmetrical?

 

a correct set of v8 headers will always be assymetrical due to the heads not being symmetrical on the block. the passenger side head sits usually about 1 to 2" back from the driver side head...also the engine is pushed towards the passenger side about 3" to compensate for the steering column, brake booster. so a v8 exhaust will never be symmetrical, if the headers are perfectly equal length and built as they should be.