BC - CAN FS: 1996 Honda Civic Hatch W/ K20Z3 And Extras
I have my car for sale. I am located in Kelowna BC Canada. Just putting this on here hoping people will share it around. I am open to delivery depending on distance, and open to trades for the vehicle. Trades that are welcome: Toyota Tacoma, Yamaha YZ 250 or higher CC dirtbike. Price that I am asking for the vehicle is 14,000 OBO.
Modification List goes as follows. (And I am sure there is a few things I am most likely missing.)
Engine: 2008 Honda Civic SI K20Z3 (approximately 30,00KM)
Transmission: 2008 Honda Civic SI K20Z3 (approximately 30,000KM)
One off, custom JBDR Long Tube Header
Custom JBDR 3 inch Exhaust
Custom JBDR Twin Loop Muffler
S90 70MM Throttle Body
K TUNED 3 Inch Cold Air Intake w/ Velocity Stack
Rywire Milspec Tucked Engine Harness
Rywire Adapter Harness
K-PRO ECU and Tune (181.1 WHP, 133.9 WTQ)
K TUNED Passenger Side Radiator Kit
K TUNED Power Steering and AC Delete Kit
Sparco Sprint Five Fixed Back Seat
Sparco 4 Point 3 Inch Belt Harness
Bride Japan Seat Rail With Slider
OMP Corsica Steering Wheel
NRG Quick Release Hub
KONI Yellow SPSS Dual Valved Shocks
Ground Control Coilover Sleeves
Eibach Springs (550lbs Front, 450lbs Rear)
Drive Shaft Shop Base Swap Axles
Honda Civic SIR Rear Disk Brake Swap
Brand New Rear Rotors
Brand New Front Rotors
Brand New Front Lower Ball Joints
Brand New Front Wheels Bearings
Hawk HP Plus Brake Pads On All Four Corners
Deatsch Works 340LPH Fuel Pump
Custom Fuel Lines
Accord 6 Speed Shift Box and Cables
Custom JBDR Shift Box Raiser
I have two sets of wheels for this car:
Enkie RPF1 x2
Konig Wideopen x2
Rays Gram Lites x2
Konig Flat out (I think) x2
Tires are brand new this year with not too many miles on them thus far. 205 50 15 Dunlop Direzza Z2
Also have 2X Kumho Ecsta XS with maybe 50-65% tread left
I also have a set of 24.5 inch Mickey Thompson slicks with Honda Civic vx wheels as skinny. The slicks are mounted on Lenso VPD wheels. I bought them used at the start of the year. I haven't used them once. I also have a Brand New In Box set of Driveshaft Shop Axles that are rated for 450 hp. Warranty with them as well. (Stage 2.9)
I am going to post a link to another add I have up on a local forum so that people can see pictures.
http://bchondas.com/forum/showthread...3046#post23046
That is all I can think of off the top of my head right now. Please share with friends, hopefully get some word out that this car is for sale. It has been babied. Never seen a track day, washed constantly, and cleaned meticulously. Send me a private message on here. I will release my mobile number and email through PM's.
Cheers everybody.
Alex
Modification List goes as follows. (And I am sure there is a few things I am most likely missing.)
Engine: 2008 Honda Civic SI K20Z3 (approximately 30,00KM)
Transmission: 2008 Honda Civic SI K20Z3 (approximately 30,000KM)
One off, custom JBDR Long Tube Header
Custom JBDR 3 inch Exhaust
Custom JBDR Twin Loop Muffler
S90 70MM Throttle Body
K TUNED 3 Inch Cold Air Intake w/ Velocity Stack
Rywire Milspec Tucked Engine Harness
Rywire Adapter Harness
K-PRO ECU and Tune (181.1 WHP, 133.9 WTQ)
K TUNED Passenger Side Radiator Kit
K TUNED Power Steering and AC Delete Kit
Sparco Sprint Five Fixed Back Seat
Sparco 4 Point 3 Inch Belt Harness
Bride Japan Seat Rail With Slider
OMP Corsica Steering Wheel
NRG Quick Release Hub
KONI Yellow SPSS Dual Valved Shocks
Ground Control Coilover Sleeves
Eibach Springs (550lbs Front, 450lbs Rear)
Drive Shaft Shop Base Swap Axles
Honda Civic SIR Rear Disk Brake Swap
Brand New Rear Rotors
Brand New Front Rotors
Brand New Front Lower Ball Joints
Brand New Front Wheels Bearings
Hawk HP Plus Brake Pads On All Four Corners
Deatsch Works 340LPH Fuel Pump
Custom Fuel Lines
Accord 6 Speed Shift Box and Cables
Custom JBDR Shift Box Raiser
I have two sets of wheels for this car:
Enkie RPF1 x2
Konig Wideopen x2
Rays Gram Lites x2
Konig Flat out (I think) x2
Tires are brand new this year with not too many miles on them thus far. 205 50 15 Dunlop Direzza Z2
Also have 2X Kumho Ecsta XS with maybe 50-65% tread left
I also have a set of 24.5 inch Mickey Thompson slicks with Honda Civic vx wheels as skinny. The slicks are mounted on Lenso VPD wheels. I bought them used at the start of the year. I haven't used them once. I also have a Brand New In Box set of Driveshaft Shop Axles that are rated for 450 hp. Warranty with them as well. (Stage 2.9)
I am going to post a link to another add I have up on a local forum so that people can see pictures.
http://bchondas.com/forum/showthread...3046#post23046
That is all I can think of off the top of my head right now. Please share with friends, hopefully get some word out that this car is for sale. It has been babied. Never seen a track day, washed constantly, and cleaned meticulously. Send me a private message on here. I will release my mobile number and email through PM's.
Cheers everybody.
Alex
Here are some pictures of the car. Sorry there isn't much, I had to get to work. I will upload more as soon as I possibly can. Thanks for the tip about the link by the way.
Please see here: http://hondamarketplace.com/announcement.php?f=64&a=44
Thread
Thread Starter
Forum
Replies
Last Post
wesuri
Southern California (Sales)
1
Jan 26, 2016 02:41 PM
Steven.
Mid-Atlantic (Sales)
1
Sep 18, 2008 06:58 AM




