JDM ITR Cat Temperature Sensor Calibration
Thread Starter
Honda-Tech Member
Joined: May 2013
Posts: 53
Likes: 0
JDM ITR Cat Temperature Sensor Calibration
Hey guys,
I installed a T1R midpipe with Mugen Twin Loop Muffler just now and to compensate for the EGT probe that goes into the new cat, I've welded a bung for it. When I started it for the first time afterwards, the exhaust overheat light came on - on cold start.
I'm taking that the calibration is off and was wondering if I could re-calibrate that. I'm guessing the probe is probably a NTC Thermistor since it only has one lead into the harness.
Anyway, any insights will be greatly appreciated.
B.
I installed a T1R midpipe with Mugen Twin Loop Muffler just now and to compensate for the EGT probe that goes into the new cat, I've welded a bung for it. When I started it for the first time afterwards, the exhaust overheat light came on - on cold start.
I'm taking that the calibration is off and was wondering if I could re-calibrate that. I'm guessing the probe is probably a NTC Thermistor since it only has one lead into the harness.
Anyway, any insights will be greatly appreciated.
B.
Thread
Thread Starter
Forum
Replies
Last Post
_VTEKNU_
All Motor / Naturally Aspirated
1
Apr 30, 2007 02:47 AM
hooptie157
Acura Integra Type-R
9
Jan 18, 2002 02:32 PM