prepping the block for turbo
Thread Starter
Joined: Oct 2002
Posts: 38
Likes: 0
From: Toronto, Ont, Canada
prepping the block for turbo
I will be getting a d16a6 this weekend.
I am going to go turbo on this motor.
What should I do to make the bottom end stronger.
I am going to be running the boost at about 10-12psi
any recomandations on pistons and connecting rods?
Honing the bores out?
I am going to go turbo on this motor.
What should I do to make the bottom end stronger.
I am going to be running the boost at about 10-12psi
any recomandations on pistons and connecting rods?
Honing the bores out?
Thread
Thread Starter
Forum
Replies
Last Post
Bulldogg83
Forced Induction
6
Oct 15, 2003 11:06 PM