Kpro ELD wont log Under 1.4v
Thread Starter
Honda-Tech Member
Joined: Jun 2004
Posts: 2,852
Likes: 0
From: Dont Steal My Car, Ct, USA
Kpro ELD wont log Under 1.4v
Kpro green board
Kmanager 3.2.2
EG hatch
stock k20a2
I have the 0-5v from my AEM uego going to E15. With the sensor unplugged, i adjust the voltage offset to match perfect.
It will log anything above 12.3ish/1.4vish (going off memory)fine, but anything under that, it will just stay at 12.3/1.4v even tho the gauge displays 10.0afr.
So i change the gauge with a known good AEM unit, with the same results. I put a meter on the 0-5v output of the guage and add alot of fuel across the map, and i get .2v at 10.3AFR and 2.xx at 14-15 AFR witch seems correct.
I call hondata, and they assure me there are not resistors that need to be removed in the ecu and it must be the AEM units fault.
Any help? Thanks.
Kmanager 3.2.2
EG hatch
stock k20a2
I have the 0-5v from my AEM uego going to E15. With the sensor unplugged, i adjust the voltage offset to match perfect.
It will log anything above 12.3ish/1.4vish (going off memory)fine, but anything under that, it will just stay at 12.3/1.4v even tho the gauge displays 10.0afr.
So i change the gauge with a known good AEM unit, with the same results. I put a meter on the 0-5v output of the guage and add alot of fuel across the map, and i get .2v at 10.3AFR and 2.xx at 14-15 AFR witch seems correct.
I call hondata, and they assure me there are not resistors that need to be removed in the ecu and it must be the AEM units fault.
Any help? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Freshdot
Engine Management and Tuning
3
Dec 11, 2012 07:11 AM
phearable
Miscellaneous - Appearance - Lighting
74
Oct 16, 2007 05:33 PM