***Skunk2 Pro 3+ cams B series ***
Thread Starter
Honda-Tech Member
Joined: Feb 2005
Posts: 1,204
Likes: 0
From: twin falls, idaho, usa
***Skunk2 Pro 3+ cams B series ***
SOLD
I got some Pro 3's for sale they have 350 miles on them, Almost like new.
They have P3+ on the end's of them.
B-series Pro 3 - IN. 277* / 13.0 ; EX. 284* / 12.4
Asking $500
Spun a main bearing, decided to go boost.
I got some Pro 3's for sale they have 350 miles on them, Almost like new.
They have P3+ on the end's of them.
B-series Pro 3 - IN. 277* / 13.0 ; EX. 284* / 12.4
Asking $500
Spun a main bearing, decided to go boost.
Last edited by mafia; Dec 20, 2012 at 02:31 PM.
Trending Topics
Thread Starter
Honda-Tech Member
Joined: Feb 2005
Posts: 1,204
Likes: 0
From: twin falls, idaho, usa
Re: ***Skunk2 Pro 3+ cams B series ***
I made 209whp on low reading dyno, 81mm 12.0:1 cr skunk2 IM was holding me back. It was on my ls/v.
Yes cams were degreed in, but no changes were made during tune.
Idle was at 1000 rpm, and IMO idle was like stock just a little higher.
Cams are pending sale.
Yes cams were degreed in, but no changes were made during tune.
Idle was at 1000 rpm, and IMO idle was like stock just a little higher.
Cams are pending sale.
Thread
Thread Starter
Forum
Replies
Last Post
j spec
All Motor / Naturally Aspirated
9
Jun 6, 2006 06:36 PM