gsr head, crank arp headstuds pic coilovers
Name: Tony
Contact: 9135638813
Zip: 66203
Asking Price: $375 w/ water pump
Item description: Selling this head that I just took off my car. Ran great no ticking or anything and many can vouch that it pulled while it was in my car. Would recommend a valve job before putting on as it did smoke in VTEC. Only thing missing is one of the studs that holds down the valve cover. And includes a water pump w/ less than ~50 miles. No throttle body on the intake manifold. No dizzy either. Head had 172,xxx miles when pulled.





PIC full body coilovers 8k/8k
One of the shocks blew out so I'm looking to sell the set. Idk how much a replacement from pic is but I want to get something more low friendly. These are great for autox and racing but not much for lowering a lot. Looking for $350obo
Fits EG/DC
Price: $300obo


GSR ARP Head studs
Been torqued once (1) $100
I have the nuts and washers also just not pictured

GSR Crank and rods (pistons not included) $150 or trade for LS crank and rods
Spun a rod bearing on cylinder 4 doesn't look to bad



Contact: 9135638813
Zip: 66203
Asking Price: $375 w/ water pump
Item description: Selling this head that I just took off my car. Ran great no ticking or anything and many can vouch that it pulled while it was in my car. Would recommend a valve job before putting on as it did smoke in VTEC. Only thing missing is one of the studs that holds down the valve cover. And includes a water pump w/ less than ~50 miles. No throttle body on the intake manifold. No dizzy either. Head had 172,xxx miles when pulled.





PIC full body coilovers 8k/8k
One of the shocks blew out so I'm looking to sell the set. Idk how much a replacement from pic is but I want to get something more low friendly. These are great for autox and racing but not much for lowering a lot. Looking for $350obo
Fits EG/DC
Price: $300obo


GSR ARP Head studs
Been torqued once (1) $100
I have the nuts and washers also just not pictured

GSR Crank and rods (pistons not included) $150 or trade for LS crank and rods
Spun a rod bearing on cylinder 4 doesn't look to bad



Thread
Thread Starter
Forum
Replies
Last Post



