Hey guys, I am in need of some serious help.....I am so frustrated. I need to know how to clear the code after setting the timing on F22. Here is how it goes:
-Installed port and polished heads
-Timing got thrown off in process...I know I'm a dumbass!!!
-Anywho, ordered new belts while I had it all apart, new timing covers (including balancer belts).
-Lined up all balancer gears-used the bolt to hold the rear balancer gear
-Timed it all back up, Code 8 CEL came on-rechecked the timing-found that the Crank pulley deteriorated and got thrown off.
-Ordered a new Crank pulley-retimed and installed new pulley.
-Adjusted to 15degress BTDC with a timing light and a jumper wire in the diagnostic plug.
-Car ran great!!!! No check engine!!!!
-Drove it a third time.....Damn-the light came on again

Please help-not sure which way to turn!!!!

 

Double check your work, a bad connection at the dist "could" casue issues.

From there, time to test the TDC ans see if it is going out.