Hey guys,
I know this is an old, well-documented issue... but I can not find an actual ANSWER to my problem...
I recently swapped out a VTEC F22B1 for a JDM VTEC F22B.... I re-wired the CKP and TDC sensors with no problem, but I am STILL not getting any fuel pressure.... I KNOW the pump worked fine prior to the swap, the B1 fired up and ran no problem (except for the hellish knocking from the rod it threw)
I am completely stumped, so I ask anyone else that may have encountered this, please help!
Thanks to all!

 

Maybe your fuel pump went bad for some odd reason just before your engine went bad?

 

I'm down to that I suppose... gna drop the tank this weekend and check it out... I'll post the results, thanks again

 

Check to see if the fuel pump is priming.

Try another ECU.

 

Ecu or main relay

 

Changed out the relay, and I have fuel pressure, but still no spark...

 

changed out ECU... and coil... STILL NO SPARK!!

 

Maybe the Dizzy

 

!!UPDATE!! Replaced ECU, relay, and dizzy.... And I am fully operational!! A HUGE thank you to all who have advice! Was most helpful!