i have a 88 dx crx with a d16z6 in it, first time i did the swap i didnt really know all too much about it and just had a guide, on top of that i rushed it. didnt turn out to well. well i just rewired everysensor and plug with a custom made harness engine side and ecu side everythings hooked up correctly and no buttconnectors this time all solder.

im alittle stumped with something tho the Alternator, i dont remember if it was charging before when i had done the swap but theres one wire coming off it i dont know where it goes it says to the eld know where the eld is and what not but i cannot find a pinout of one theres three wires. im guessing ones a ground and i know the two other ones one comes from the Alternator and one comes from the ecu D10

i would just like to know what goes where on the eld 3 pin connector and if im right about it

last thing i have to figure out besides getting a speed sensor in before this beast is alive again thanks guys

 

Not sure, but this may help...: