UT: FS Sleeved b series built turbo motor.
Thread Starter
Honda-Tech Member
Joined: Jan 2002
Posts: 2,583
Likes: 0
From: UT, USA
UT: FS Sleeved b series built turbo motor.
motor was built by courtney green. made 670 whp.
dave
801.628.7060
MOTOR
Details:
comp stage 4 clutch, 0 miles. $250
ATI dampener $225.
Full race traction bar $175.
ARP head studs $90
Moroso OIL Pan $150
Block $1300
b16 block bored out to 84mm (roughly 1.8ltr) b16 crank
Custom JE pistons 9.0:1
ACL Race bearings
Manly forged rods
Block is fully sleeved with RS sleeves (capable of 36+psi)
stock oil pan.
TOP HALF: $600
B16 head fully ported and polished with valve job
Supertech Titanium springs and retainers (handle 10k rpm all day long if needed)
Skunk2 Pro series High Compression standard size Valves
no cams or valve cover
Custom ported valve cover, for catch can setup. $175.
port matched edelbrock intake manifold. $250.
dave
801.628.7060
MOTOR
Details:
comp stage 4 clutch, 0 miles. $250
ATI dampener $225.
Full race traction bar $175.
ARP head studs $90
Moroso OIL Pan $150
Block $1300
b16 block bored out to 84mm (roughly 1.8ltr) b16 crank
Custom JE pistons 9.0:1
ACL Race bearings
Manly forged rods
Block is fully sleeved with RS sleeves (capable of 36+psi)
stock oil pan.
TOP HALF: $600
B16 head fully ported and polished with valve job
Supertech Titanium springs and retainers (handle 10k rpm all day long if needed)
Skunk2 Pro series High Compression standard size Valves
no cams or valve cover
Custom ported valve cover, for catch can setup. $175.
port matched edelbrock intake manifold. $250.
Thread
Thread Starter
Forum
Replies
Last Post
1qucksol
Classifieds: Forced Induction
18
Nov 25, 2009 09:42 AM