I have a cb7 and I am going to do a h22 swap on it but the h22 is a obd2. I was wondering since I have all the obd2 stuff how hard would be to make my car obd2?

 

I'm interesting of this too

 

I found out Its really hard. I am just going to made the motor obd1.

 

 

it is a LOT easier to buy an obd1 distributor and ecu and run it that way.

 

Thats what I did. I was just asking because I had a obd2 ecu.

 

I go the way to stay motor obd2. Install F23a 1999y. in CB3 with all wires and ECU.
need to connect ecu harness to salon harness^
starter signal, power, power to memory ecu, ground, fuel pump (wire from ecu to main relay) - what is all